What is the difference between a farmall a and super a

You must include your email address above to receive this notification. Rear View Backup Camera. Engines Misc. How much is your farm tractor worth? Find resale prices for tractors built from through today, with complete specifications and serial numbers. Don Brackett. My Super A, No , also a 53 has very thick sleeves in it and I'm fairly certain the bore is still 3".

Where did you find the C stamped on your block? SAm in NS. Sam: My apologies, I did some better cleaning, put my reading glasses on and re checked that number. Turns out that number is the casting code. What I thought was C is actually that blob they use Then it is 12, and the second blob looks like a 3.

Then of course is another 2 blob and an X then blob again. I sure hope this didn't cause you too much grief. Again my apologies. Sam: It is in raised letters directly behind the distributor and just below the lettering for fireing order. This was brought to my attention on these foruns one night about 3 weeks ago. It also seems reasonable that IH would want to use the same block after the introduction of the SC with the C engine. One casting to serve twice the tractor numbers.

Lets not forget the size of the engine That is the most important part! While I am on the subject.. What is the difference in an International A and a Farmall A?

What are the main differences between an A and a Super A? Is an A more rare than an Super A? Does a Super A have hydraulics? Looking for one to put a belly mower on and just to have around the farm. I have always loved Farmall "letter" tractors.

Steiger Man. Sunburst Montana. Strasburg North Dakota. I would take that super A in a flash. Super A has Hydraulics , A does not. Super A should be worth more than an A, even if the A is in better shape. Price of these has gone down with the drop in Tobacco acreage. That said , Woods made a Hand lift mower for the A.

I assume they still make it? I forget how many of each were made. Pretty sure there were more Super A's built. Also made 's, 's and 2 styles of 's. Callled the offset styling Cultivision. Just be careful if the left wheel is set in close, lot's of folks killed here with wheel set close on the offset side. Set it out and the tractor is pretty safe. Started out on one over 50 years , used it today to load out a load of corn on an 8 inch auger.!!!!!!!!!!!!

If you buy one and need a mower deck for it. I have one.